Audio files for Multicast Mode

• Related Articles

• Audio Files

  What type of audio files can be uploaded into the Intercom or Office Ringer? RIFF (little-endian) data, WAVE audio, Microsoft PCM, 16 bit, mono 8000 Hz, no spaces between words in the file title. You can use the free website utilities G711 File ...

• Config Files

  By default, config files are titled: exported_config.xml The file must be extracted before upgrading the firmware. If the firmware is upgraded and the device is not restored to factory default settings when extracting the config file, you will get a ...

• Paging Server Multicast Configuration with CyberData Products

  The following is in regards to setting up multicast between the CyberData 011146 SIP Paging Server and other CyberData products. 011146 SIP Paging Server with Bell Scheduler – CyberData Corporation Note: The Paging Server in these examples is already ...

• CyberData Products and RFC 2833.

  CyberData devices only support RFC 2833 Dual-Tone Multi-Frequency (DTMF) digits. Our devices require Real-time Transport Protocol (RTP) event notifications to process DTMF; which is supported by the vast majority of the telecom industry. Our devices ...

• 600 Ohm Lo-Z Connection to CyberData Paging Amplifier

  How do I connect a 600 Ohm Lo-Z input or output to the V2 Paging Amplifier's Line Input or Output? The V2 Paging Amplifier's Line Input and Output are 10K Ohm Hi-Z. 600 Ohm (Low-Z) Pageport audio devices can interface with the Paging amplifier using ...