CyberData Home Tech Support
Knowledgebase: VoIP > General
Cycling Power With Cisco 3550
Posted by CyberData Administrator, Last modified by CyberData Administrator on 13 February 2015 01:54 PM

We have the Cisco 3550 switch and it looks like the unit is not able to negotiate the power with the switch. It keeps cycling over and over.

This happens because with default settings, the switch port is resetting power too quickly. Therefore, on the 3550 switch, on the switch port that the unit is attached to, please try adding the following CLI command:

power inline delay shutdown 20 initial 300

That should keep power supplied until the unit can boot up all the way.